phunaraww™ Clover Loop Adjustable Dog Harness — Padded Y-Front Walking Vest, Back Leash Clip, Sage Grid, Small

Clover Loop pairs a small-scale, original sage-and-cream grid with peach binding and a tiny embroidered clover on the chest panel. The proposed Y-front layout leaves an open space between the front legs, while a padded chest section adds a soft contact surface. Adjustable neck and chest straps let you refine the fit within the listed range rather than relying on a breed label.

Two side-release body buckles allow the chest straps to open for dressing, and one metal back D-ring provides the leash attachment point. This listing is for the Small harness only; the leash is sold separately. The harness is intended for ordinary, supervised walks with an appropriately fitted adult dog. It is not described as escape-proof, no-pull, crash-tested, or a lifting harness. A correct fit and ongoing handling are essential.

The little details ✨

• A quieter kind of print: The small grid gives the walking set a polished look without large novelty graphics.
• Padded chest panel: Fabric-covered padding adds a soft layer at the front of the harness.
• Adjustable neck and chest: Multiple adjustment points allow fit changes within the Small size range.
• Two body buckles: Open the chest section rather than asking your dog to step through fixed loops.
• One clear leash point: A single back D-ring keeps the intended attachment location obvious.
• Coordinated, not bundled: Matches Ribbon Trail and Little Reward; each item is priced separately.

Product Details / Size Guide

Proposed Small fit: neck 11–15 in; chest girth 16–22 in. Measure neck at the harness neckline and chest around the widest rib area just behind the front legs. Both measurements must fit the range; do not select by breed or weight alone. Main strap width: 0.75 in. Materials: polyester woven outer and webbing, polyester mesh lining, polyester padding, plastic adjusters and buckles, metal back D-ring. No front leash ring, handle, ID tag, reflective-performance claim, or leash included.

In the Box: 1 Small Clover Loop harness; 1 illustrated fitting and care card.

⚠️ Fit Before Every Walk

Proposed sizing is not a tested load rating; release requires fit and strength verification. For supervised walking only. Not for vehicle restraint, tie-out, tethering, lifting, or climbing. Adjust for a snug fit with room for approximately two fingers; ensure the dog cannot back out during a gentle indoor check. Remove when unattended or crated. Inspect all hardware and seams before use. The complete Care & Use Guide is included below.

KEEP FOR FUTURE REFERENCE

📖 Care & Use Guide — Clover Loop

Remove packaging before use. Inspect before each use. If your pet may have swallowed a product part, stop use and contact a veterinarian promptly.

1. Measure neck and chest and compare both with the Small size range. Inspect webbing, D-ring, seams, adjusters, and buckles before dressing.
2. Open both body buckles. Pass the neck opening over the dog’s head without forcing it, position the Y panel on the chest, and route body straps behind the front legs without twisting.
3. Close both buckles until they click; gently pull each connection to verify closure. Adjust symmetrically for a snug fit with approximately two fingers of clearance. Check for rubbing at the armpits and neckline.
4. Attach the leash only to the back D-ring. With the dog calm indoors, gently check forward and backward movement to ensure the harness stays in position. Do not walk outdoors if the dog can back out or the hardware shifts. Recheck fit regularly.
5. Remove after walks and whenever unattended. Handwash in cool water with mild detergent; rinse and air-dry away from heat. Inspect after drying. Replace if any buckle, ring, stitching, or strap is damaged; do not use improvised repairs.